POTASH (Potassium Carbonate K₂CO₃) ~ pH Adjuster & Scouring Agent

POTASH – pH ADJUSTER & SCOURING AGENT

Chemical name: Potassium Carbonate (K₂CO₃) | Grade: Textile | Use rate: 3–10%

No natural-dye studio is complete without potash (Pottasche in German). This alkaline powder (K₂CO₃) is slightly stronger than soda ash and is traditionally used to raise the pH of dye baths and indigo vats, scour cellulose fibres, and intensify plant yellows such as weld by increasing alkalinity.

💡 Note: This product was previously listed as Soda Ash (Sodium Carbonate). We have updated the listing to Potash (Potassium Carbonate) to reflect the correct material.

Uses

• Boost pH in indigo, woad, or fructose vats
• Add to your scouring bath
• Intensify weld yellow and other plant yellows
• Balance acidic dye baths when needed

In a nutshell

• Material: Potash (Potassium Carbonate K₂CO₃)
• Function: pH enhancer & cellulose scour
• Dose: 30–100 g · L⁻¹ (3–10% owf) dissolved in hot water or dye liquor
• Compatibility: All natural dyes; indigo & woad vats
• Packaging: Resealable moisture-proof pouch
• Safety: Wear gloves & mask; store cool, dry, and away from acids

Basic directions

Dissolve the required potash in hot water (or directly into a hot dye bath) at 3–10%. Stir until clear, then add to the dye pot or fibre scour. For indigo vats, add potash after the pigment to adjust alkalinity before introducing a reducer.

Safety & storage

Potash is strongly alkaline. Avoid inhaling dust and protect eyes and skin. Store sealed and dry; keep away from children and acids. Dispose of effluent according to local regulations.

💡 Tip: Pair potash with our Natural Indigo Powder or Indigo Kits for a complete dye setup.

Potash vs Soda Ash Table